Multi-way L.E.D Magnifying Lamp
INTRODUCTION
Thank you for purchasing a Cobolt Speechmaster Multi-way L.E.D Magnifying Lamp.  Please take a few moments to read these instructions, particularly those on INSTALLATION and the WARNINGS & SAFETY PRECAUTIONS, before you connect your Lamp to the power supply.

KEY FEATURES
1. 2-IN-1 floor and desk lamp.
2. 5x magnifying optical glass
3. Three colour modes; warm, natural and white light.
4. Dimmable option for each colour mode.

WARNINGS & SAFETY PRECAUTIONS.
5. Check all parts of the lamp for any damage.
6. Do not operate the lamp if any damage is found to the lamp or the stand/clamp.
7. Do not use the lamp on a wet or hot surface.
8. Always use the lamp on a level surface.  

FLOOR STAND INSTALLATION
1.  Remove all packing materials and accessories and retain them, in case you need to return the Lamp to us in the future.
9. Place the lamp’s base in a level location. 
10. Assemble the 3 poles by screwing them together and then to the base. (Please note that the 1,2 or all 3 poles can be attached, depending on the users requirement)
11. Place the lamp into the hole at the top of the pole attached to the base (see diagram on page 4).
12.  Plug your  lamp’s connector into the adaptor’s connector and then plug the adaptor into a standard 220 - 240 volt 13 amp household outlet. 

CLAMP INSTALLATION
13. Remove all packing materials and accessories and retain them, in case you need to return the Lamp to us in the future.
14. Fit the clamp to a desk or table and tighten using the lever at the bottom.
15. Insert the bottom of the lamp into the clamp and tighten the knob to hold the lamp firm.
CONTROL BUTTONS
There are 4 buttons on the control pad

Control button’s from top to bottom
· Increase brightness. 
· Change colour mode.
· Decrease brightness.
· On/Off.
OPERATING THE LAMP 
16. Press the ON/Off button to switch on the lamp.
17. Press the colour change button to switch between warm, natural and white light modes. 
18. Press + (increase button) or - (decrease button) to change the level of brightness. 
CARE AND CLEANING
19. Use a soft dry cloth when cleaning.
20. Do not rinse or immerse in water.
21. When not in use for long periods of time turn off or remove adaptor from the wall. 
22. Do not attempt any repair should the lamp go faulty, doing so could void the warranty.
IF you have any questions regarding the lamps operation or functions please contact Cobolt Systems LTD using the information on the back of this instruction manual.